Support
VSTHM1600
Has the water tank run dry?
If the water tank has run dry, the safety thermal cut out may have been activated
Leave the machine for 2 hours and try the following:
Fill the water tank halfway
Turn the machine on and wait for it to heat up (until the steam light comes on)
Place your hand over the body of the machine, to see if the machine feels warm
Machine warm?
No?
Yes?
Press the trigger and check to see if steam is released
No Steam?
Go to 'Have you checked the machine for a blockage?'
Have you checked the machine for a blockage?
Switch the machine off and unplug from the wall socket
Use a small thin object (such as a paperclip) to clear any blockage from the nozzle
Retry the machine holding the trigger in for 1 minute (or until steam appears)
No steam?
Go to 'Have you descaled the tank?'
Have you descaled the tank?
Switch the machine off and unplug from the wall socket
Allow time for the machine to thoroughly cool down before removing the water tank lid
Using a descaling product, descale the tank and then retry
No improvement?
Go to 'Have you checked the hose?'
Have you checked the hose?
Complete a visual check of the hose
Are there any kinks/splits/tears on the hose?
Yes?
A replacement hose is required, go to 'Spares' tab above
No?
Clearing a blockage
Turn off and allow time to thoroughly cool down
Remove any blockages by inserting a small thin object (such as a paperclip) into the nozzle
Has the machine been without power for over 24 hours?
Have you changed the fuse? If not, please replace the fuse in the plug with another 13 amp fuse
Fuse changed and still no power?
Is there an unfamiliar smell coming from the machine?
There are no products matching the selection.