Support
VUAM1200A
Is there air sucking through the vent at the top of the dirt container?
This indicates a blockage
Go to 'No suction' for instructions on how to clear
Is it a whistling noise?
Remove the dirt container, open the bottom and clean all seals
Replace the dirt container and retry
Noise still present?
Cleaning the pre-motor filter
Remove the dirt container and turn the lid anti-clockwise
Remove the dirt container lid
Remove the pre-motor filter
Tap the filter against the side of a bin
Rinse filter under the tap (no detergent) and allow 24 hours to air dry
Is there a red flashing light on the base?
Something has obstructed the brush bar. Remove brushbar cover and clear any debris from around the brushbar itself
Recline the machine until it is lying flat on the floor
Press the brushbar reset button (located on the top of the base) 3 times
Press the power button to switch the machine back on
The green light should now display and the brushes should be turning
If no light is on the base, press the brushbar on/off button (directly in front of the power button) to activate the brushes
The green light should now appear and the brushes should now be turning
Is there no light on the base?
Recline the handle on the machine and switch the machine on
Press the brushbar on/off button on the machine
The brushbar should now be turning
Brushbar not turning/no light?
Is the green light on but the brushbar not turning?
Due to the speed of the brushbar, it is sometimes difficult to establish if it is turning
Recline the handle on the machine and switch the machine on
Whilst looking at the brushbar itself, switch the brushbar on/off button on and off a few times
You should see and hear the brushes stopping and starting
Green light on and brushbar still not turning?
Emptying and cleaning the dirt container
Remove the dirt container
Release dirt from the dirt container
Remove the dust separator
Tap the separator against the side of a bin
Use a soft brush to remove any remaining debris
Has the machine cut out whilst in use?
The machine is equipped with a safety thermal cut out, which is designed to activate if the air cannot flow through the machine as it should. Allow 24 hours for the machine to cool down thoroughly, in the meantime go to 'No suction' for advice on how to clear the blockage.
Has the machine been without power for over 24 hours?
Have you changed the fuse? If not, please replace the fuse in the plug with another 13 amp fuse
Fuse changed and still no power?
Does the machine go on and off when moved?
Have you checked the suction from the motor?
Remove the dirt container and switch the machine on
Place your hand over the two holes located at the top of the machine, this is where the lid of the dirt container is normally attached to
If the suction is strong, go to 'Have you cleaned your filters?'
No suction?
Have you cleaned the filters?
Remove dirt container
Remove the lid and lift the filter out of the top of the dirt container, tap to get all of the dust off
Rinse the filter under the tap (max 40 degrees, no detergent) allow at least 24 hours for it to fully air dry before placing back in the machine
Remove the separator from the dirt container
Inspect the holes for blockages and clear debris
No improvement?
Go to 'Have you checked the hose?'
Have you checked the machine for a blockage?
Switch the machine off and unplug from the wall socket
Disconnect the hose from the base at the front of the machine
Undo the screw underneath to remove the brushbar cover
Visually inspect the brushes for any obstructions
Still experiencing a problem?
Have you checked the hose?
Remove hose from the base of the machine and remove the dirt container
Drop a small ball of paper down the top of the hose, this is where the hose meets the dirt container
Is the paper stuck?
Yes?
There is a blockage and this will need to be removed
No?
Complete a visual check of the hose
Are there any splits/tears on the hose?
Yes?
A replacement hose is required, go to 'Spares' tab above
No?
Go to 'Have you checked the base for a blockage?'
Cleaning the post-motor filter
Remove the dirt container
Twist to release the filter and cover
Tap the filter against the side of a bin – DO NOT WASH
Removing a blockage from the hose
Remove the hose from the base
Remove the dirt container
Push a wire coat hanger (or something similar) through the hose to remove the blockage
Clearing a blockage from the brushbar
Switch the machine off and unplug from the wall socket
Turn the machine over and undo the screw underneath
Undo the brushbar cover clips
Remove the brushbar cover and clear any obstructions
Re-setting the brushbar
If the red light appears, recline the machine
Press the brushbar reset button 3 times
Switch the machine on
The green light should appear
If brushes don’t turn, press the brushbar on/off button
-
Vax Pro Cleaning Kit VPCK
An all-in-one premium cleaning tool kit for your Vax vacuum - for effortless cleaning around the home. Contains: crevice, radiator, upholstery, up-top and mattress tools, pet hair attachment, and stubborn and soft brushes.